Psion Teklogix ISO 9001 Uživatelský manuál stáhnout pdf (Strana 19)

Chapter 2: Hardware Information

The LED

Psion Teklogix NEO HDK User Manual 11

2.3 The LED

A single tri-coloured LED is located on the upper-left corner of the NEO, just above the dis-

play. Default behaviour of the LED is described in the table below. The LED can also be

controlled by application programs, using APIs found in the Psion Teklogix Mobile Devices

SDK (see Appendix A: “Resources” for details on where to obtain this SDK).

2.4 Battery & Power Management

The NEO is powered by a 3300 mAh lithium-ion rechargeable battery pack, and can also be

connected to an external power source using a docking station or AC wall adaptor. When the

NEO is connected to an external power source, the battery pack also charges.

When the battery output drops below 3.1 V, the hand-held will go into suspend mode to

preserve information in volatile memory until the battery is recharged or replaced with a

charged battery. If the battery output drops below 1.6 V, the hand-held will shut down

completely, and any information in volatile memory will be lost.

Use only power sources recommended or sold by Psion Teklogix for the NEO.

LED Behaviour Charge Status Scanner State

Solid Green Charge complete. Successful decode

Fast Blinking Green Charge in progress. Battery charged to

less than 80% capacity.

N/A

Slow Blinking Green Battery charged to greater than 80%

capacity.

N/A

Solid Red Temperature outside charge range

°C to 50 ° C / 32 °F to 122 °F).

Scan beam ON

Blinking Red Battery is not charging. Battery fault. Decode timeout

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Žádné komentáře

Psion Teklogix ISO 9001 Uživatelský manuál Strana 19