Psion Teklogix PrintAbout MP2000 Specifikace Strana 30

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 61
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 29
Printek Emulation
Printer Controls
Bell BEL
Causes the printer's bell to sound.
Control code: BEL
Hexadecimal: 07
CANCEL CAN
Deletes all data in the printer’s input buffer and resets the printer to power up default values. Refer to “Printer
Reset Conditions
” on page 55 for more information.
Control Code: CAN
Hexadecimal: 18
Print Contrast ESC P n
Sets the contrast, or relative “darkness”, of the characters or graphic images to be printed where 0 n 9
(hexadecimal 30-39). A value of zero provides the greatest contrast and also the slowest print speed. Likewise,
a value of nine provides the lowest contrast, but the fastest print speed. The default value is “5”.
Since contrast is greatly affected by the quality of thermal paper being used, this command allows varying
grades of paper to be printed on successfully.
In association with this setting, the printer automatically adjusts the contrast while printing in order to achieve
consistent output based on the current battery condition and print head temperature.
Example: The following escape sequence with set the printer to a Print Contrast setting of “4”.
Escape Sequence: ESC P 4
Hexadecimal: 1B 50 34
Buffer Mode ESC P #
ESC P $
Buffer Mode may be used to force the printer to “hold” data until the entire print job is received.
If Buffer Mode has been enabled, the printer continues to hold data in its input buffer until an EOT character
(Hexadecimal 04) has been received. Once the EOT is received, the printer will print the data in the input
buffer up to the EOT character.
When Buffer Mode is not enabled (default) data are printed as received.
Example 1: The following escape sequence enables Buffer Mode.
Escape Sequence: ESC P $
Hexadecimal: 1B 4D 24
Example 2: This escape sequence disables Buffer Mode.
Escape Sequence: ESC P #
Hexadecimal: 1B 4D 23
26
Zobrazit stránku 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 60 61

Komentáře k této Příručce

Žádné komentáře