Psion Teklogix PowerScan M8300 Uživatelský manuál stáhnout pdf (Strana 180)

REFERENCES

163

cannot be successfully completed, then the code is added to the list. When the

reader returns in range, transmission of the codes to the base station resumes

automatically, according to the selected communication protocol, upon simply

pressing and releasing the trigger or by successfully reading a new code.

Each code is listed on the reader display together with its identifying position number

and its total number of characters. The three keys under the display have the

following function in batch mode:

Key Function

▲ (left) Key Scroll up in list

ENTER

(center) Key Delete highlighted code

▼ (right) Key Scroll down in list

In batch mode, the selected Transmission Mode determines the behavior of the

reader at the time the list of codes is transmitted. If One-way mode is enabled, the

codes are transmitted one after the other without interruption. In Two-way mode,

after transmitting each code, the reader waits for the Host answer message to be

shown on the display. Therefore, in Two-way transmission mode and normal batch

mode, the Start Normal Batch Transmission bar code must be read after each

code to continue, whereas with automatic batch mode just pull and release the

trigger after each code.

The code, which has a transmission pending, is shown on the display in reverse

video indicating that it cannot be deleted.

5.9.8 Find Me (PowerScan

M8300 only)

If enabled, after a timeout of a few minutes in which PowerScan

M8300 is not used,

it enters stand-by mode and its green LED starts blinking in order to signal its

location.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 219 220

Žádné komentáře

Psion Teklogix PowerScan M8300 Uživatelský manuál Strana 180